Features and parameters of grab type cleaning machine

1, the bridge rail design of the cleaning machine makes the working plane clean and tidy, so that the effective working area of the working platform is optimized.

2, the installation position of the support column can be flexibly positioned with the site conditions to adapt to any site conditions.

3, no submerged parts, so improve the reliability of the equipment, and reduce equipment maintenance.

4, short maintenance cycle, twice a year.

5. Long life cycle of all transmission units.

6. Low noise operation is suitable for urban sites.

7, the working load is between 250 kg and 3000 kg (refers to the single claw cleaning weight).

8, grid bar spacing in the range of 12mm to 200mm(or above).

9, cleaning depth up to 50 meters.

10, the vertical grid can also be cleaned.

11. The two sides of the claw are open, which can remove dirt such as long tree trunks, and can easily remove dirt such as wood, oil drums and plastic sheets.

12. The system does not require a recoil sink or a grid slag conveying unit. The cleaning claw can transport the dirt directly to the discharge area.

13. Multiple emission zones can be considered.

14. The guide rail can be made into a curved track form to complete the dumping of dirt to the designated place.

15, the operating speed is in the range between 10 meters and 60 meters per minute, which can reduce the overall cleaning cycle time in the wider grille area.

16. Automatic operation can be achieved through manual control, time control and liquid level difference control. At the same time, remote monitoring can also be realized.

17, it can also be manually operated by hand control handle. This feature is particularly useful in the event of a failure of the machine control unit.

18, low power consumption, energy saving, reduce operating costs.

19. Structural design meets environmental protection requirements.